You are currently viewing our forums as a guest, which gives you limited access to view most discussions and access our other features. By joining our community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join the ATVConnection Forums community today!
I've read all I can read. I know these are known for being built like a tank. I know a guy in central arkansas that has put 14,000 miles on his!
Question is, how good is the Hondamatic Transmission?
I've read about a few people haveing trouble that turns into an expensive fix. Just doesn't seem as reliable as an old manual shift.
I found a Rubi in north Arkansas for $3500, maybe a bit less. It's at a dealership and I will be asking about the extended warantee, but still want some advise.
I can handle bearings, ball joints, ect, but tranny problems and major electrical issue scare me. Let me know what you guys think. Has about 3400 miles.
I run my rubicon HARD and mine has been flawless with 2k miles, Iv taken it to the dunes and held it wide open all day long threw salt water and river corssings and also pulled a 4x10 trailer full of wood up a 20% grade 2 mile long logging road floored in low range @ 15mph the entire way four times a year during wood cutting! the tranny is MAJIC when the going gets slow and tricky it makes the trail easy! Id say its just as bulletproof or maybe even tougher than a gear tranny as gear tranny shifting forks wear duirng hard abuse.
There does seem to be regular posts about the Rubicon going into limp mode because the computer detects a fault.
I think if you cleaned all the connectors with contact cleaner and compressed air, then hit them all with diaelectric grease, you would prevent some problems.
Having a service manual would also be a way to reduce the cost of a problem, if you were to have one. A lot of the time it's something like the angle sensor, or a connector or the shift motor needs cleaned up. As long as you know how to retrieve codes and how to reinitialize the computer it shouldn't be too bad.
Actual failures of the hydrostat drive it's self I think are pretty rare.
How much to replace the oil pump?
Just curious, I found a newer 500 Foreman for only $2700, but sounds to good to be true, so maybe.
Also found 01' Rubicon w/ 3k miles. Dealership asking 3500, but may take less.
Having said that, they won't be able to tell if the oil pump has been done or not.
Replacing an oil pump would depend on the hourly hate the shop charges .. On warranty Honda pays 6.5 hours flat rate , but it actually takes in the 10 hour range plus the price of the oil pump & gasket kits A & B ...
I wouldn't replace the pump unless it had a problem, not all of the 2001s were bad.
Several of our friends have Rubicons. Two of them had oil pumps fail and Honda told them it was due to some metal shavings left in the pumps by the manufacture. I believe these 2 Rubicons were 04s. One only had 400 miles on it (owner NEVER rides it) and the other one had about 1600 miles on it. They were both over 2 years old and Honda took care of both of them with no cost to the owners.
I beleive that Honda stands behind their products better than any of the others do.
I sure wish they would build a 650 Rubicon.
__________________ 2014 750i EPS
currently 1444 miles & 126.7 hrs