Still no front Brakes on Recon
#2
Try cracking open the line right at the master cylinder,you may have a big bubble trapped high where it can't get pushed down to the wheel cylinder. If you have access to a syringe or something to push fluid with,try reverse bleeding.You put a hose on the bleeder and force fresh fluid from the cylinder to the master on the handle bar(empty the master first,or you will make a mess.) Air is hard to push down hill,so reversing the flow uphill will make sure it all comes out. If that fails,you may have a bad master cylinder,and will need a rebuild kit,just a couple of seals and springs,won't cost too much.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)