lt80 carnage
#1
#2
Sucks. been there a few times.
No goo gasket cuz that stuff is microns thin. The base gasket is around .018.
You could goo it up. It'll lower the cilinder but on a stock motor there shouldn't be a problem with clearances.
I have gaskets and such.
I also have a set of good cases if you need them.
Did it break the exhaust port off the cylinder?
No goo gasket cuz that stuff is microns thin. The base gasket is around .018.
You could goo it up. It'll lower the cilinder but on a stock motor there shouldn't be a problem with clearances.
I have gaskets and such.
I also have a set of good cases if you need them.
Did it break the exhaust port off the cylinder?
#3
Sucks. been there a few times.
No goo gasket cuz that stuff is microns thin. The base gasket is around .018.
You could goo it up. It'll lower the cilinder but on a stock motor there shouldn't be a problem with clearances.
I have gaskets and such.
I also have a set of good cases if you need them.
Did it break the exhaust port off the cylinder?
No goo gasket cuz that stuff is microns thin. The base gasket is around .018.
You could goo it up. It'll lower the cilinder but on a stock motor there shouldn't be a problem with clearances.
I have gaskets and such.
I also have a set of good cases if you need them.
Did it break the exhaust port off the cylinder?
can you pm or email me a price of a base gasket, and two piston wrist pin clips please, just the clips i need, i have several new wrist pins and all
for right now i have a spare lt80 i've been taking parts off of, so im taking the bottom end out for this quad and after that im done with the lt80's lol, my girlfriend graduated to a blaster so we took your stage two parts off of her quad and put it on my 10yr olds lt80, but we got him a blaster too that he is getting used to. all i need is one more blaster for my 8yr old but he wants a *sigh* 250ex
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)