Milled head LT80
#1
Milled head LT80
Hi
I'm from Denmark and new to this forum.
My son has a '06 LT80 which I want to make some mods to. I have been reading a lot about mods to the LT80 on this forum and this is my plan.: Boysen reeds, milled head 0,030, 2,5 inch wheel spacer in front, turn the rear wheels. LT160 front shocks, Denso iridium plug.
My question is when you write 0,030 off the head is that in mm or inch ?
Jack Moore.: - do you sell a ported cylinder with new piston and will you send one to Denmark ?
Best regards
Kell
I'm from Denmark and new to this forum.
My son has a '06 LT80 which I want to make some mods to. I have been reading a lot about mods to the LT80 on this forum and this is my plan.: Boysen reeds, milled head 0,030, 2,5 inch wheel spacer in front, turn the rear wheels. LT160 front shocks, Denso iridium plug.
My question is when you write 0,030 off the head is that in mm or inch ?
Jack Moore.: - do you sell a ported cylinder with new piston and will you send one to Denmark ?
Best regards
Kell
#2
#3
Thread
Thread Starter
Forum
Replies
Last Post
jrooker6
Polaris
18
04-23-2016 07:36 PM
Quadzilla Heritage
Classifieds, Garage Sale & Swap Shop
0
09-25-2015 01:39 PM
ATVC Correspondent
Classifieds, Garage Sale & Swap Shop
0
09-23-2015 06:23 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)