gas leak 2001 magnum 325 need help.
#12
Now I'm freaked out too....I only ran the machine for about a 1/2 mile after I filled it and it seemed to run fine. I don't know if a stuck needle would cause it to run bad. The true test will be when I get home to check the dipstick. I am calling the dealer that I bought it from to have a conversation with them. I really hope they are willing to work with me on this. They assured me this machine had been gone thru... I know there's a sucker born every second...
#13
Now I'm freaked out too....I only ran the machine for about a 1/2 mile after I filled it and it seemed to run fine. I don't know if a stuck needle would cause it to run bad. The true test will be when I get home to check the dipstick. I am calling the dealer that I bought it from to have a conversation with them. I really hope they are willing to work with me on this. They assured me this machine had been gone thru... I know there's a sucker born every second...
#14
Talked with the dealer and they said they would help me out. I brought it back to them this a.m. so hopefully I will know the problem in a few days. They didn't say they would pay for the entire repair but that we would work something out. The fact that they didn't just say too bad it's used and walk away from it makes me feel better about the situation. One week from my daughter's birthday when I can finally give it too her.....I'm excited.
#15
#16
Well, just got the news that is was the needle and seat in the carb.. It filled the motor with gas and also ate away the air filter. the dealer is rebuilding carb, replacing the air filter, draining oil and filter, with no cost to me for parts and we will split the labor. To me more than fair considering is was a used purchase. kudos to Northway Sports in East Bethel, MN. You have a loyal customer...
Thread
Thread Starter
Forum
Replies
Last Post
Stirling
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
4
08-09-2015 01:49 PM
Hankey Pankey
Performance Mods and Project Quads
1
07-31-2015 05:50 PM
Hankey Pankey
Technical and How-To Articles
0
07-29-2015 10:57 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)