You are currently viewing our forums as a guest, which gives you limited access to view most discussions and access our other features. By joining our community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join the ATVConnection Forums community today!
its easy for the most part. i did have a bit of a hard time getting the belt to seat into the pulley. i had to tap it in using a hammer handle. you my as well change you springs and weights wile your in there and clean it.
what do u mean by replacing the springs and weights? i'm not very mechanicly inclined and am curious about what all will need to be done. did u have to replace the gasket seal cover? a few people have recommended i do. thanks for your help
they told me i could have problems with altitude, and if i put a new pipe on that increased power. did you have any of these problems. They also said that I would need the 79 dollar tool to put this on. did you buy this, and if not how did you get yours on? thanks
as far as altitude i am 80 feet above sea level so no problem. i have the stock pipe. i didnt buy the 79 dollar tool, but it would have made the job easyer. i cant remember exactly how i did it, but i do remember i used a vice, a c-clamp and an extra set of hands.