You are currently viewing our forums as a guest, which gives you limited access to view most discussions and access our other features. By joining our community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join the ATVConnection Forums community today!
Does anyone know what the stock setting for the air/fuel mixture screws on an 05 Raptor 660? I need to know how many turns out they should be from bottomed.
Also, Does anyone here run a Yoshimura pipe? If so, did you have to change your air/fuel mixture settings.
With a powerlid and Yosh exhaust, would the screws have to be turned in, or out? After putting the pipe on, my friend changed the jets out to 150/155. With them at 1.5 turns, it starts popping at 2000rpms and the pipe gets red hot near the head.
now when you guys say 2 1/2 turns out on the fuel screw on stock setup.... is that two full 360 degree turns followed by one 180 degree turn? or two 180 degree turns followed by one 60 degree turn?
Someone please respond ASAP i need to get my raptor going ASAP.
what happend was i went for about a 30 minute drive and it ran great just after about 20 minutes of riding up and down hills over and over i was on a hill for about 20 minutes just riding on it and it started to idle really low almost like it wanted to shut down i revved it and it started to back fire and when i got home it got worse so im thinking the elevation screw up the fuel srew or something, any suggestions?