97 Yamaha Wolverine Very hard to shift, adjustment bolt/screw goes all the way in!!
#1
97 Yamaha Wolverine Very hard to shift, adjustment bolt/screw goes all the way in!!
Hey guys,
I picked up a wolverine 4x4 recently, runs and drives pretty good for all-time 4wd. I noticed its very hard to shift up/down. I read on the forums that the adjustment screw on left side could be out of adjustment. So i loosened the nut and started running the screw in counter clockwise, was expecting it to bottom out, but it never did. So i stopped when it was flush with the case cover. I need some advice as to why this would not be bottoming out or giving and resistance at all?
I picked up a wolverine 4x4 recently, runs and drives pretty good for all-time 4wd. I noticed its very hard to shift up/down. I read on the forums that the adjustment screw on left side could be out of adjustment. So i loosened the nut and started running the screw in counter clockwise, was expecting it to bottom out, but it never did. So i stopped when it was flush with the case cover. I need some advice as to why this would not be bottoming out or giving and resistance at all?
#2
Thread
Thread Starter
Forum
Replies
Last Post
Arh
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
7
11-09-2015 01:52 PM
trapstar56
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
3
11-03-2015 09:07 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)