Check it out, pictures of my banshee finished project.
Dec 16, 2003 | 08:43 PM
#4
Extreme Pro Rider
Joined: Jul 1999
Posts: 2,858
Likes: 0
Check it out, pictures of my banshee finished project.
Looks good, but im not all that hip on the seat. Also, those pipes, if they are not bolted to the foot pegs are going to give you a problem down the road..
Again, looks good though, what are ya runnin motor wise?
RoostKing...
Again, looks good though, what are ya runnin motor wise?
RoostKing...
Dec 16, 2003 | 10:39 PM
#7
Pro Rider
Joined: Nov 2003
Posts: 448
Likes: 0
Check it out, pictures of my banshee finished project.
Nice Banshee[img]i/expressions/face-icon-small-happy.gif[/img]
Trending Topics
Dec 16, 2003 | 10:42 PM
#8
Thread Starter
|
Pro Rider
Joined: Jun 2002
Posts: 1,245
Likes: 0
Check it out, pictures of my banshee finished project.
lol about the pipes, I didnt think anyone would notice. There's a few things needed, like I didn't take a picture of the other side, because there is no stator cover on it, and there is no ignition box either.
It's a 370 stock bore with a 4mm stroker from K&T. Full drag ported, K&T billet head, 35.5 carbs, pro-design intake, override tranny, and a lot more.
I'm not too big on the seat either, I think I'm going to either sell it, or take the cover off and shave the back foam down a little. When the people did the seat, they were told to take an inch off the back "hump" but instead, they added an inch of foam. Dumbarses.
It's a 370 stock bore with a 4mm stroker from K&T. Full drag ported, K&T billet head, 35.5 carbs, pro-design intake, override tranny, and a lot more.
I'm not too big on the seat either, I think I'm going to either sell it, or take the cover off and shave the back foam down a little. When the people did the seat, they were told to take an inch off the back "hump" but instead, they added an inch of foam. Dumbarses.
