my cuz is still in high school and is in metal shop he says that he teacher bored a couple main jets for other ppl and said he could do my 130 to get it to a 150 is this a good idea just for now until i go to a shop ( there about 50 miles away and usually not the way im going)

 

I wouldn't do that myself. It is too cheap to buy jets and they are more likely to be accurate as long as you get them from the same source.

 

Welcome back NC. How are you doing?

Lukester

 

There is a conversion chart that will tell ya the bit you need and if get the right bit they work fine have used a few myself and no problems.

 

thanks lukester, still recovering here. Doing well though,

 

whats up NC its been a long time good to see you back i was just a noob when i last heard from you...

 

Yep it has been a while, I remember you being a newbie too, believe it or not. lol