Well I went riding last weekend with my 700sp and the mud and water was pretty deep. My seat got full of water and I was wondering what is the easiest way to dry it out without pulling the cover and throwing the foam in the drier. It weighs about 50lbs. now. I have it sitting on end hoping it would drain. but that's not happining. Any suggestions?

 

looks like youll have to take the cover off
or leave ti in the sun itll eventually dry

 

lol.. isnt it fun being that deep... i went last fall... (f'ing cold outside too) and i was bag deep for like 20 mins. i got stuck in the mud/water hole... earlier in the ride i busted a CV shaft so i only had 3wd on the 700 i was on... and i got it stuck... bad.

 

Dont put it in the sun. I did this with a jet-ski seat, and the foam hardened. Just prop it up in the garage and let the water leak out of it slowly...

 

Thanks for the replys. Yea this was seat deep for about 9 hours off and on. When it came time to clean it up I even had to take the headlight pod off and clean the mud out of there, but I only had to get pulled out one time. Needless to say the other brands tend to shy away from going on "mud runs" with our group[img]i/expressions/face-icon-small-blush.gif[/img], although they are still invited if they dare [img]i/expressions/face-icon-small-happy.gif[/img]