I know it's not about atv's, but is it possible to bore it by putting a 5hp piston in 2hp block. If so, does it tear anything up.

Thanks

 

it might be a little easier to buy a new engine. most ppl dont bore there lwan mower engines or in this case a weed wacker

 

isnt the elite the 50cc scooter? I had one and it was belt driven and geared to overrev at 40MPH tops.

 

its 49cc, but mines not belt driven

 

I kinda race lawn mowers.U can bore out 1 kind of lawn mower engine.The type of engine is a kohler.We have a cub cadet bored .020 over and a 1999 ford lawn mower we bought blown up for 200!!!!!!It has a kohler 19 hp v twin.The crank got turned.it didn't need bored because U could still see the hone marks in the cylinder walls.It did get new rods and pistons though.Other engine's like briggs and straton have the wrong kind of sleeve to be bored.

I have a craftsman with a 11hp briggs and straton.It has a 20 hp carb.My dad used a die grinder to make the intake larger and The head has been becked.It kinda runs needs some more carb tunning.It is faster than all my freins though.It realy will ride a wheelie!!!!U can see it in the back ground of the pick where I am wheelieing kmy 300ex on my web site.


www.angelfire.com/me3/fmf86trx250r