How does the blue HMF look on the blue bike. Also, how does the Powder coating hold up to rock chips, etc.
I am at 3500' With full HMF, ESR intake, where should I start in jetting? I bought the YZ needle. Thanks

 

Anyone????

 

Well I know the red looks good on the red bike, the ones ive seen with blue on blue look good. Everyones starting points seem to be @ this roughly.

170 Main
45-48 pilot
YZ needle on clip 3-4
2-2.5 turns out on the air screw

might try www._ _ _central.com too its forbidden to say the word, guess atv connection is scared everyone will run off to the other site.
I'm sure if you're running a slip on or full system, air lid no air lid, or a different filter setup it may vary just a bit.

 

we have the red one and it seems to hold up well