I just finished installing the dynojet kit on my BF650 after installing a HMF slipon kit. Got everything in and swapped out just fine, but can't seem to find the mixture screw. I see the drain screw (allen head) but am wondering if the mixture screw is under that small cap marked with black paint?

Before I pull the plug I just want to make sure I'm not drilling a hole in my bowel cover... that'd be bad.


Thanks for the help, I searched this first and haven't found any solid info. Even looked at the parts breakdown on kawi's site but it didn't really show an exact location.

 

Thanks for the replies, ha. I went outside right after posting this and it was under the caps as I figured. Adjusted out 3 turns as DynoJet stated. I'm currently riding at around 200 ft, but will be moving to Spokane and it's around 2k ft from what info I've found.

1st impression? OMG, whole new bike. She fired right up and ran like a bat out of hell. I did notice some part throttle stutter, but hammer down and off she goes. I guess I'll just have to mess with leaning and richening her out.

 

Hey I apperciate your thread. I haven't been on the forums in a few days and recently helped a friend put a slipon on his 650 brute. I looked for the mixture screws in the same place as my 700 and they weren't there, imagine that, LOL. I was wondering where kawi moved'em to and now I know. Thanks