I'm going to tackle the rear wheel bearings but didn't get too far.

What size is the rear castle nut? I have a 26mm socket, but no such luck. Any help would be appreciated, thanks.

 

someone has to know this answer...it's simple.

i'm looking for the answer so i can get a socket today to continue working on the project.

 

Not sure but it,s right out in the open can,t you take it off with a cresent or large channel locks and Guesstimate 100 ft/lb reinstal.

 

Not sure on the size myself. Have you contacted the service dept. at your Polaris dealer? I'm sure they could tell you. I get little tips from the folks at mine a lot.

 

take a tape measure and check it. i dunoo if thats gona be the same size nut as the new one but i can look at mine and see.

 

The hubs never changed since 96.

 

well then. quess ill have to ceck since no one else wants to..... that means im gona have to dig for my big sockets, go outside, take the cap off, try sockets come back it and type the size.... ill be back in afew hrs.

 

it's an 1 1/8 inch socket

 

thanks. i have a 1 1/8 wrench, but it's too big...and the 1 1/16 is too small, but I'll try that socket.

 

its a 27 or 28mm. but i had totaly forgot to check the size i got side tracked. ill check it tomorrow. sorry