I have a broke off wire in the front of my warrior, its black with a yellow line down it and then I have a solid one right beside it. They intertwine together in the same wrap, I just have to know what this hooks up to and what its for. So anyone with a warrior please look and tell me what it hooks up to. Thanks ..... Mark

 

from what i can see on the electrical diagram it has something to do with the starting circuit cut-off relay. better splice it back together or something.

 

wait a min here you say black with a yellow line, looks like its the clutch switch. will it start?

 

Well there for a while it would just turn over without fireing up, the only way I was able to fire it up was to bump start it or hook it up to a car and jump it. Could that have something to do with it??? To me it just looks like two ground wires that were unhooked from an I-connecter. But I just baught a new starter and new battery so I'll have to try it out or something... Let me know if that would cause my warrior to not fire up. Like I said it does turn over but just doesnt fire up.

 

well according to the wiring diagram i got the yellow and black wire goes to the first post and the black and yellow wire goes to my second post. if it is the black with yellow strip it is the clutch switch i just dealt with that one.

try and trace it down and follow where it goes. it would help.

 

where at in the front did it break off? near the ignition coil? stator? neutral position sensor?

 

i am assuming it is under the hood with all the other wires. dont know though.

 

It is under the hood with all the other wires... where do i hook it up at?

 

is it by the clutch handle

 

that is your clutch switch. you need to splice the wire back together or cut the other one that also goes into the and connect them together. with it broken it is not completing the circuit.