ATVConnection.com ATV Enthusiast Community

ATVConnection.com ATV Enthusiast Community (https://atvconnection.com/forums/)
-   Arctic Cat (https://atvconnection.com/forums/arctic-cat/)
-   -   Winch Selonoid Placement (https://atvconnection.com/forums/arctic-cat/279251-winch-selonoid-placement.html)

Crypto 12-14-2007 07:57 PM

Winch Selonoid Placement
 
I'm going to install a winch tomorrow. I'm curious where you guys who have the same model have placed the selonoid?

thanks

Off_Road_Ram_01 12-14-2007 10:00 PM

Winch Selonoid Placement
 
1 Attachment(s)
Mine's under the seat - pretty much between were the front seat mounts come down at.

Attachment 26673

Crypto 12-14-2007 10:28 PM

Winch Selonoid Placement
 
great. Thanks for the pic

rango726 12-14-2007 11:33 PM

Winch Selonoid Placement
 
thats were most people put them. they dont really leave you much room to put them

Off_Road_Ram_01 12-14-2007 11:40 PM

Winch Selonoid Placement
 
No not much room anywhere - I was debating putting in the storage trunk too, but found it just barely fit there. Was debating cutting the wires that came with the winch to reduce the amount I had to stash by the battery.

Crypto 12-15-2007 07:01 AM

Winch Selonoid Placement
 
no there isn't much room. THanks again guys

rango726 12-16-2007 10:41 PM

Winch Selonoid Placement
 
you should cut all your wires to length. if you have all theat extra slack the extra wire just cut it and go with the amount that you need. if you read your directions it will tell you if you need to route the wires further than what they supply than youll need to go up a wire size. this is because of the voltage carried through the wire if its too long than your voltage drops and you dont get the max out of your winch. if it even works at all granted your not going to see any difference if you cut off the extra wire or leave it especially were its only 6" of wire but. but you should cut it to size just to clean up the install

Crypto 12-17-2007 06:27 AM

Winch Selonoid Placement
 
what do you guys recommend for the switched power source? I was going to tie into the accesory on the handlebar, but I see it's not switched. I'll dig around and find one, but if you guys may be able to make it easy for me.

QuadRidinCPA 12-19-2007 04:28 PM

Winch Selonoid Placement
 
Sorry if I'm too late, but at the front of the handlebar, below the plastic piece, you will see a wire with a female bullet connector end on it. That's where you are supposed to plug it into. That's where it's at on my '06 anyway. Hope that helps.

Crypto 12-19-2007 07:30 PM

Winch Selonoid Placement
 
thanks. Do you mean inside the instrument panel or under the handlebars behind the body panel. I don't see a wire in the instument panel


All times are GMT -5. The time now is 02:28 AM.


© 2024 MH Sub I, LLC dba Internet Brands