had one of those cant remember where the cdi was or what the pin count was on it.. Pretty good little engine bullet proof

 

Just ordered new cdi, coil, and battery......He will be putting them on today or tomorrow

 

Still need help! Put the new battery & cdi's in and it spins but no fire. The man we bought it from said something about a sensor on the flywheel. I have looked everywhere and can not find a maneto that has 18 coils. Anyone know about a sensor that is on or near flywheel? Also could this be the wrong magneto? Need to get this thing fixed. Ty so much in advance. Note there is only one shop/person where I am that deals with these & he is more interested in selling you a new one.

 

is it getting spark or just will not fire up?

 

hi z.....I don't know if it's getting stark.....The old man I got it from screwed it up wiring changing out parts etc. He did say something about the magneto or flywheel sensor. I can not find an 18 coil magneto anywhere. I need to find a wiring diagram for this motor. It want to turn over but does not my nephew thinks it's a wire. Any clue where I can find the wiring diagram? Thank you in advance.
Nancy

 

Zrock are u anywhere near alabama I will pay u to get it running lol...

 

I bought my Marshin 2007 Marshin MXT200 from a dealer near Asheville,NC actually they called the place Swannanoa,NC. I bought it new in the crate, the manual wiring diagram was nothing even close to the ATVs wiring, my engine has 220cc stamped on it and 5sp
manual trans, the CDI is a dc box and you must have a battery, it has 2 plugs, small plug
goes to the battery. As I said the manual was usless, I had to do a google image to find the CDI box wiring and also searched youtube to finally figure out how to rewire the CDI.

 

Helpppppppppppppppppppppppp..............I wish I would have never bought this damn thing.

In the shop I can not find or owner can not find a top end rebuild kit. It needs cylinder, pistons, head gasket. Can the cylinder be changed out to a different one. any advice much appreciated

 

still looking for parts for this damn Marshin 200cc atv need top end rebuild. The shop has lost parts. I do not want to replace engine please help if u can. tyvm

 

Why would an engine with 7 miles on it need a top end rebuild? If you still had the cylinder, an old vintage car/bike rebuilder's dodge is to find a piston slightly bigger than the bore, with the same gudgeon (wrist) pin size and crown height, and get the bore machined to suit it. Does the bike have the actual makers name on the plate shown in the photo? Marshin may be a name thought up by the importer, the Chinese manufacturer may still be going.