Anyone good with wiring? 250 wont start, anyone even heard of New Star? Thanks
#1
Anyone good with wiring? 250 wont start, anyone even heard of New Star? Thanks
Hello 😁 So I traded an iPhone for a New Star 250 that was not currently running. All parts are there. The issue... the wiring harness is intact however A good deal of the wires are not wired anywhere? I tried to jump start via jumper cables to green and red wires coming from starter. The engine cranks but wont run. Replaced spark plug but there is no wire currently hooked up to the igniter coil. It only has 1 female spade prongs coming off from it. Ive searched high and low and cannot find info on new star atvs in general? Is anyone good with wiring china quads? I have no idea where any of these wires go ie. Start button, kill switch. Headlights and the rest can wait, just want to get her running, thanks in advance. Anything helps
Thread
Thread Starter
Forum
Replies
Last Post
Keith Reightler
Test Your Signatures (sigs) Here!
0
03-10-2017 07:48 AM
Humbert
Yamaha
12
05-11-2005 11:07 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)