2006 Rancher AT esp shift code
Hi folks,
I have a 2006 rancher at 400. Had an esp code blinking 6 times I reset the position angle sensor and cleaned and greased all the conectors. Now I have a error code blink 12 now. Any comments would be great. Thanks, Fishands |
2006 Rancher AT esp shift code
0 blinks: No problem
1 blink: ECU 2 blinks: ES Shift up / down shift system or shift release / related wire harness or ECU 3 blinks: Angle sensor 4 blinks: Gear position switch system 5 blinks: ECU motor driver 6 blinks: ECU fail-safe relay circuit 7 blinks: ECU Voltage convert circuit 8 blinks: Angle Sensor control motor 9 blinks: Angle Sensor short or related wire 10 blinks: Ignition pulse generator 11 blinks: Speed sensor 12 blinks: Gear position switch its probably your gear switch but i posted the rest of the codes in case you have any more problems. i think all these problems people have with ES should tell honda something |
2006 Rancher AT esp shift code
The TRX400FG/FA Hondamatic codes are ...
================================================== ================================================== ========================== https://img372.imageshack.us/img372/...00codeswo9.jpg ================================================== ================================================== ========================== This is the tests for code #12 ... ================================================== ================================================== ========================== https://img372.imageshack.us/img372/...0codes2mn2.jpg https://img181.imageshack.us/img181/...0codes3nz5.jpg |
Rancher wont start
I have a 2006 Honda Rancher 350ES 4x4.....the shifter position shows --- but the green neutral light is on. The darn thing turns over but wont start...CDI just changed.....no spark at the spark plug
|
The 350ES has a totally different engine and gearbox to the 400AT. Try changing into 1st with the manual gearchange lever, then change back down into neutral. The --- mean it is in between gears, unless they are flashing Morse, in which case they are telling you which fault is on, not sure if the above fault code list is for the ES or the AT, the person who posted it seems unclear.
|
Originally Posted by merryman
(Post 3463760)
The 350ES has a totally different engine and gearbox to the 400AT. Try changing into 1st with the manual gearchange lever, then change back down into neutral. The --- mean it is in between gears, unless they are flashing Morse, in which case they are telling you which fault is on, not sure if the above fault code list is for the ES or the AT, the person who posted it seems unclear.
|
If it won't shift with the emergency lever, remove the shift motor, if it still won't shift manually, you have a mechanical problem with the linkage inside the clutch cover. Usually it is the lever which engages the pawl that turns the star wheel, or the pawl, broken or cracked, or the star wheel come loose on the end of the shift drum. However on 350s only, I have known the rod which holds the shift forks to break through the crankcase into the clutch housing.
|
All times are GMT -5. The time now is 12:53 AM. |
© 2024 MH Sub I, LLC dba Internet Brands