Cutting Fenders
I was woundering if any one has cut there own fenders and what is the best tools to use and best way to do it to keep it symetrical. How do u make them look so cleanly cut.
|
Cutting Fenders
To determine where you want to cut them use a dry erase pen. That way can can mark your fenders a few times while figuring out where you want to cut them. It just wipes off.
I have cut the fenders with a jig saw with a fine cut metal blade. Some people use a rotozip, but i find I have better control with a jig saw. After cutting you can sand the edges of the fender with fine sandpaper to take off any rough spots and to knock down the edge of the cut. |
Cutting Fenders
ok sounds good but how do u get a gloss look back or dont you.
|
Cutting Fenders
just like red 400 said i use a dry erase then i just use a gringer then i just go on the top at a slight angle an do the same to the bottom then sand with 80 then 160 then 220 sand paper then i just wash the bike real good soap and water then just give it a nice glassy wax. we race mostly in sand so i dont have to worry about getting it dirty, just other bikes behind me [img]i/expressions/face-icon-small-wink.gif[/img]. it gets a lil dusty is it. just use like a rag and wipe em down i sumtimes spay on this glossy looking liquid i dont remember the name of it right now just to keep the look there from time to time
|
Cutting Fenders
ok thanks
|
All times are GMT -5. The time now is 12:26 AM. |
© 2024 MH Sub I, LLC dba Internet Brands