changing bearing carrier on 450r
I have an '07 trx450r that i need to change the axle bearing carrier on. I can't seem to find any way of taking the axle nut off. I called the local Honda shop and they told me it was reverse thread. It has 2 places to get on the axle nut with a wrench that are 2 different sizes so I'm thinking this is a two piece axle nut. If someone has done this and can give me some advice on how to get the axle nut loose I would really appreciate it. Thanks in advance.
|
As you were told they are reverse thread.
I ordered special wrenches from www.rockymountainatv.com because I could not find any other wrenches that would fit them except for large pipe wrenches. OK, what you need to do is, turn the inside nut (the one closest to the rotor) so that it is moving closer to the rotor, move it as far as you can. Then you need to turn the outside nut in the same direction, this will expose a retaining split-ring on the axle that you remove and then unscrew both nuts off the axle. If you don't have the proper size wrenches it's a real pain in the ass. There is probably locktite on the nuts so it will help if you heat them with a torch. Good luck. |
thanks
Hey thank you. I'll try that this evenong. You're right about the pipe wrenches. Thats all I have that will fit and they are a pain. I guess first thing would be to heat the nut up. I'll give it a shot thanks.
|
can anyone tell me the size of he bigger nut on the axle of the 450R...
|
Two different sizes 45mm and 56mm
|
Originally Posted by alicia2303
(Post 3018301)
can anyone tell me the size of he bigger nut on the axle of the 450R...
https://cimg4.ibsrv.net/gimg/atvconn...bf47fc3583.jpg Hope this helps from a 06+ honda trx450r axle I removed. |
All times are GMT -5. The time now is 12:49 PM. |
© 2024 MH Sub I, LLC dba Internet Brands