08 prairie 360 clutch ?
#1
08 prairie 360 clutch ?
Have a line a a really clean 08 360 for cheap . The guy was replacing the clutch and thinks he stripped the bolt bc he didn’t know it was reverse threads . It will tighten back down a little but as soon as you give it any kind of gas it slips. Can the crank be re tapped and threads cleaned easily . And also does anyone know the thread pitch and specs on the clutch bolt trying to decide if it is worth it to pick the bike up
#4
Yes, talk to someone that has plenty of exp repairing threads.
I screwed up my prairie 400 threads by using a puller which didnt have the correct dia on the end so as I was tightening the puller it was going into the crank and rounding the tops off the crank threads.
I was able to gradually thread in the clutch bolt using plenty of lube and threading the bolt in and out, re-lubing, and threading in a tiny bit further, removing and lubing, etc. that was 11 years ago and all is well.
I bought a reverse tap and never had to use it. It is a m12 x 1.25 LH Tapco tap. That was over 10 years ago.
If your clutch bolt threads are destroyed, it might be possible that the crank threads just need touched up with a reverse tap.
Again, my machine is a prairie 400. Year 2000 4x4. I checked kawasakis fische and it appears to me they use the same primary clutch bolt. They say 12 x165 so I believe that means 12mm x165mm.
I screwed up my prairie 400 threads by using a puller which didnt have the correct dia on the end so as I was tightening the puller it was going into the crank and rounding the tops off the crank threads.
I was able to gradually thread in the clutch bolt using plenty of lube and threading the bolt in and out, re-lubing, and threading in a tiny bit further, removing and lubing, etc. that was 11 years ago and all is well.
I bought a reverse tap and never had to use it. It is a m12 x 1.25 LH Tapco tap. That was over 10 years ago.
If your clutch bolt threads are destroyed, it might be possible that the crank threads just need touched up with a reverse tap.
Again, my machine is a prairie 400. Year 2000 4x4. I checked kawasakis fische and it appears to me they use the same primary clutch bolt. They say 12 x165 so I believe that means 12mm x165mm.
Thread
Thread Starter
Forum
Replies
Last Post
ConcoursQuebecCanada
Kawasaki
1
03-04-2003 03:58 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)