Can't get it started!
 

Can't get it started!
 

Any ideas on what is wrong w/this quad.
Sundiro Ridgerunner 50cc, 2 cycle.
Has spark, getting fuel to the motor, has 65psi for compression.
I have even shot fuel into the cylinder and carb just to see if it would pop.
It does nothing but turn over.
Any ideas out there?

Can't get it started!
 

Try starting fluid and a new spark plug. Make sure the air filter isn't clogged. And make sure the exhaust isn't plugged, if there's a spark arrestor, it might need to be cleaned.

Good luck.

Can't get it started!
 

Isn't 65psi a bit low for compression?

Can't get it started!
 

I was not sure if the compression is low for this quad.
I have tried the starting fluid into the cylinder and carb w/out airfilter installed.

Can't get it started!
 

65psi is too low. You held the throttle open while testing?

Can't get it started!
 

I do not think that I had the thottle open when checking the preasure. Does it make a difference?

Can't get it started!
 

You're reading will be low if you don't.

Can't get it started!
 

I will test it again then. What should I be getting for PSI? I am not familiar w/2 cycle motors and their corks.

Can't get it started!
 

Over 100, I would think.