GIO 110cc Spider Electrial Issues
#1
GIO 110cc Spider Electrial Issues
What works:
Turn Lights on Break light works.
If I ark the solenoid the bike does run.
What doesn't:
Head light
Break light when applying breaks.
Won't start with hand controls.
Also noticed that red wire from fuse to handle bar kill switch and start switch get warm/hot.
Does anyone have a god wire diagram.
Any help is good
Turn Lights on Break light works.
If I ark the solenoid the bike does run.
What doesn't:
Head light
Break light when applying breaks.
Won't start with hand controls.
Also noticed that red wire from fuse to handle bar kill switch and start switch get warm/hot.
Does anyone have a god wire diagram.
Any help is good
#3
More checking and the fuse link only gets hot when lights are in the on position. Putting foot on break does not light up the breaks. So really have no power at all but arking solenoid will start bike and run fine.
The teather I shorted the the two leads which should rule out that.
Both front and rear breaks have leads going to them for safety switch do both need t be closed before bike will start?
The teather I shorted the the two leads which should rule out that.
Both front and rear breaks have leads going to them for safety switch do both need t be closed before bike will start?
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)