2007 polaris sportsman 800 wont start - Page 2 - ATVConnection.com ATV Enthusiast Community



Polaris ATVs - Ask an Expert! An area where experts in their field will answer non-general questions about your Polaris ATV.
"old polaris tech" and other experts will answer your questions as they have time.
ASK ALL GENERAL QUESTIONS OR BASIC QUESTIONS IN THE POLARIS FORUM.
Basic or General questions posted in a expert section will be moved!

Reply
 
Thread Tools Search this Thread
  #11  
Old 03-01-2017, 08:35 AM
Weekend Warrior
Thread Starter
 
Join Date: Feb 2017
Posts: 24
Default

I'll try this thank you
Reply With Quote
  #12  
Old 03-01-2017, 02:46 PM
Weekend Warrior
Thread Starter
 
Join Date: Feb 2017
Posts: 24
Default

I checked this and there is no corrosion at all but I notice are the cv shaft in the front supposed to have play
Reply With Quote
  #13  
Old 03-01-2017, 03:22 PM
old polaris tech's Avatar
Polaris ATV Expert
Retired and loving it!
 
Join Date: Jun 2008
Location: North Texas
Posts: 21,788
Default

All of them have some play after a while.
Reply With Quote
  #14  
Old 03-01-2017, 03:24 PM
Weekend Warrior
Thread Starter
 
Join Date: Feb 2017
Posts: 24
Default

Ok just checking it has play were it goes in the diff is that normal too
Reply With Quote
  #15  
Old 03-01-2017, 03:41 PM
old polaris tech's Avatar
Polaris ATV Expert
Retired and loving it!
 
Join Date: Jun 2008
Location: North Texas
Posts: 21,788
Default

There will be some play from the output hubs in the front diff. If really excessive,then the output hubs may need to be replaced.Items#2 and 5.
Attached Thumbnails
2007 polaris sportsman 800 wont start-ab68a7dfb8ee8ba24cae1f8d97221436a2a8f53d.png  
Reply With Quote
  #16  
Old 03-02-2017, 09:03 AM
Weekend Warrior
Thread Starter
 
Join Date: Feb 2017
Posts: 24
Default

Do you know what part of the device manila it tell you how to take out the front diff
Reply With Quote
  #17  
Old 03-02-2017, 09:16 AM
old polaris tech's Avatar
Polaris ATV Expert
Retired and loving it!
 
Join Date: Jun 2008
Location: North Texas
Posts: 21,788
Default

Here's a Rzr front diff removal. Procedure is pretty well the same on removal except on a lot of models you may also have to pull the radiator back to have enough room to get it out.
There are short cuts that people have taken and just dropped a-arms and tie rods and pulled struts out far enough to remove drive shafts from the diff.
Reply With Quote
  #18  
Old 03-02-2017, 11:12 AM
Weekend Warrior
Thread Starter
 
Join Date: Feb 2017
Posts: 24
Default

Ok so I have the diff out took the cover off everything is entact the plate the sprague cage is good is there anyway I can bench test it I'm lost
Reply With Quote
  #19  
Old 03-02-2017, 02:40 PM
old polaris tech's Avatar
Polaris ATV Expert
Retired and loving it!
 
Join Date: Jun 2008
Location: North Texas
Posts: 21,788
Default

Pull the roll cage out and inspect close for any small cracks on the cage. I'd still replace this cage with an aluminum one and be done with it. Also replace the armature plate and case seals. If the output shafts,bearings,etc still look ok you can reuse them,but check carefully. If in doubt on the coil itself,check the ohms reading between the hot wire and ground wire.Should be between 22.8-25.2 ohms.If reading exceeds this,possibly time to replace the coil plate.Polaris Sportsman 450 500 700 800 ALUMINUM Front Differential Roll Cage Sprague | eBay
Reply With Quote
  #20  
Old 03-02-2017, 03:02 PM
Weekend Warrior
Thread Starter
 
Join Date: Feb 2017
Posts: 24
Default

I took the front end to my dealer he said the cage roller are rough and so if the part they ride on I think it's the hub is pretty sought he said it other then that it looks good I'm just trying to find the best deal he said through polaris it's bout 400
Reply With Quote
Reply



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



All times are GMT -5. The time now is 07:47 PM.


 
  • Ask a Question
    Get answers from community experts
Question Title:
Description:
Your question will be posted in: