Dies when I'm stopped
 

ok, my Polaris 325 Trial Boss just recently started "thowing a fit" about a week ago. Whenever I come to a stop and let go of the throttle it dies, My guess would be that the throttle cable needs adjusted but it only does it about 15 minutes after I start riding. Can anyone help me out?


Thanks,
Jeff

Dies when I'm stopped
 

give your air mixture screw a half turn out... it worked for me..

Dies when I'm stopped
 

k thanks, anymore advice before I try this? Where is the mixture screw? which way is "out"? left or right?



Thanks
Jeff

Dies when I'm stopped
 

It sounds like something in the throttle body(area on the handle bars in the black box) remove the 3 screws and take off the cover and gasket, and see if the connection isn't being made in the box......if no connection, then your motor won't run. I hate that darn setup in that box.......has something to do with stopping throttle sticking.

Dies when I'm stopped
 

k thanks

Dies when I'm stopped
 

on the right handle bar there should be cable that has rubber pieces that are black and if you spread those rubber pieces away from each other you should see like a piece that you twist and have the 4 wheeler running and twist 1 way and see if the engine is getting bigger rpms and have it in nuetral

Dies when I'm stopped
 

I did that and it idled fine but I am worried that since it is loose now it might move around and re-adjust to idle higher and higher.... Has anyone else done this? Is it safe/recomended?

Dies when I'm stopped
 

Wow thanks, I found out that other little nut to re-tighen it in its place. Thanks a lot, no more keepin on the gas and wearin down my brakes for me!

Thanks a lot,
Jeff