2009 850XP stabilizer bar
#1
2009 850XP stabilizer bar
Its been a long time since I have been in this forum but have a question to ask
I recently got some bighorn 2.0 tiers mounted on my stock steel rims. When I went to install the wheels on the ATV I found that the side lugs of the tires would hit the corners of the rear stabilizer bar. I think this was an issue when I was on the forms back in 2010 and guys were somehow bending the bars. I did try this with a bar with no luck. 1" on both sides would be perfect.
Is it possible to bend the bare 1" on either side without cracking or breaking the bar? I don’t want to run 1" wheel spacers if possible.
Thanks
I recently got some bighorn 2.0 tiers mounted on my stock steel rims. When I went to install the wheels on the ATV I found that the side lugs of the tires would hit the corners of the rear stabilizer bar. I think this was an issue when I was on the forms back in 2010 and guys were somehow bending the bars. I did try this with a bar with no luck. 1" on both sides would be perfect.
Is it possible to bend the bare 1" on either side without cracking or breaking the bar? I don’t want to run 1" wheel spacers if possible.
Thanks
#2
Thread
Thread Starter
Forum
Replies
Last Post
850xp4me
Classifieds, Garage Sale & Swap Shop
6
03-31-2010 09:39 AM
KAWIFAN
Classifieds, Garage Sale & Swap Shop
0
07-07-2009 05:39 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)