CV boot replacement problem(scram 500)...please help
#1
I'm a little confused on how to get new CV boot on.I have the machine on a lift with the front drive axle out of the front strut.I cut off the damaged boot.Now what?Do I remove drive axle from center gearcase and forcefully slip on that way?How do I remove it?Do I take apart CV joint?how?I have a service manual but it very confusing reguarding this precedure.While I'm asking a drift punch would be?Thank you all for helping.Duh,almost forgot 2000 scrambler 500 4X4.CV protectors ordered already.
#2
The drive shaft will pull out of the wheel hub . It has a circlip on it that will compress under some pressure of tugging on it . It is kinda tapered inside as to let the circlip compress . Give it a few sharp tugs on it and it should come right out , however sometimes they put up a fight .
#6
Thread
Thread Starter
Forum
Replies
Last Post
Rooky
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
10
06-23-2015 09:35 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)