ATVConnection.com ATV Enthusiast Community - Search Results

 
Search: Posts Made By: Ujoint
Showing results 1 to 25 of 169
Search took 0.04 seconds.
Forum: Polaris
06-10-2008, 09:48 AM
Replies: 4
Views: 1,377
Posted By Ujoint

04 sportsman 500 gear case help

I replaced all the bearings and gears in my '02 - the gears I got off of Ebay (when I got the quad, it had lived in the mud and the gear teeth were worn so badly they "howled")
Lot's of the "guts"...
Forum: Polaris
06-10-2008, 09:34 AM
Replies: 5
Views: 569
Posted By Ujoint

cam shaft question

The camshaft and exhaust rocker arm are not high profit items, so finding it much less than the $220 ( about $30 over dealer cost) and $60 for the exhaust rocker arm ( about $10 over dealer cost) is...
Forum: Polaris
06-08-2008, 09:06 AM
Replies: 9
Views: 799
Posted By Ujoint

Where can I get a starter rebuild kit?

Polaris part # 3084981 - Starting Motor seems to fit all of the Single Cylinder 4 cycle engines from 325 to 500 (except the Xpedition - manual shift)

You can verify your part # at:...
Forum: Polaris
06-05-2008, 09:00 AM
Replies: 9
Views: 799
Posted By Ujoint

Where can I get a started rebuild kit?

You can try www db-starter-alternator.com/Starter%20Motors/ATV/
$47.95 for a brand new 1 year warranty starter - we've used them for years and out of hundreds of starters we've bought, only had...
Forum: Yamaha
06-04-2008, 10:13 AM
Replies: 3
Views: 2,371
Posted By Ujoint

1986 moto 4 will only pull start

Starter and battery are good places to start looking - There has to be enough engine rotation for the ignition stator to start producing electricity to run the ignition system. Also weak compression...
Forum: Yamaha
06-04-2008, 10:03 AM
Replies: 5
Views: 1,260
Posted By Ujoint

Big Bear Ball Joints how loose or tight

A new ball joint is going to have some resistance, but not like that of a car. With use and age, they will get loose. What you are mainly looking for is the amount of "up and down" movement the...
Forum: Yamaha
06-04-2008, 09:55 AM
Replies: 4
Views: 26,265
Posted By Ujoint

Air/Fuel Mixture Screw - Raptor 660

The needles are tapered, so if you have the clip in the top groove, you have dropped the larger part of the needle's taper down into the needle jet - reducing the amount of fuel. If you place the...
Forum: Yamaha
06-03-2008, 09:52 AM
Replies: 4
Views: 26,265
Posted By Ujoint

Air/Fuel Mixture Screw - Raptor 660

The air mixture screw regulates the amount of air to fuel for the idle circuit in the carb - on most 4 stroke carbs the screw controls the amount of fuel being delivered through the idle circuit -...
Forum: Honda
06-03-2008, 09:17 AM
Replies: 6
Views: 2,419
Posted By Ujoint

honda rancher 350 FE 4x4 2002 shifting problem

<div class="FTQUOTE"><begin quote>Originally posted by: HondaMechanic

I would check the speed sensor ..</end quote></div>

I agree - the most common cause for "u can be riding for awhile and as...
Forum: Yamaha
05-30-2008, 09:16 AM
Replies: 1
Views: 455
Posted By Ujoint

Bad knocking on 04 Grizz

Pull the primary clutch off and start the engine to see if the noise is still there - this should isolate if it is clutch or engine...... Of course it could even be in the centrifugal clutch (which...
Forum: Honda
05-30-2008, 09:02 AM
Replies: 8
Views: 14,347
Posted By Ujoint

Honda 300 Differential rebuild

<div class="FTQUOTE"><begin quote>Originally posted by: HondaMechanic

side clearance is more inportant than tooth pattern ..</end quote></div>

HondaMechanic, Why would you say the side...
Forum: Arctic Cat
05-29-2008, 08:47 AM
Replies: 1
Views: 550
Posted By Ujoint

water problem

Sounds like water in the carburetor - try draining the carb bowl and see if it runs any better. You may even have to remove the carb bowl to get all the water/trash out.
Forum: Polaris
05-28-2008, 09:13 AM
Replies: 3
Views: 432
Posted By Ujoint

02 500 sprotsman no spark problem

The single spark condition usually points to the pulse (trigger) coil - pull the recoil starter housing off and check the air gap first. A lot of times "foreign stuff" gets in there and will hit the...
Forum: Honda
05-27-2008, 09:38 AM
Replies: 4
Views: 4,445
Posted By Ujoint

Need parts for 86 trx350 4x4

Some parts are still available thru Honda - There are some parts for this that have been discontinued due to age and the few years that they produced this machine. You will also find some...
Forum: Polaris
05-27-2008, 09:17 AM
Replies: 12
Views: 2,694
Posted By Ujoint

Water pump still leaking????

Your mechanical seal is what is causing the leak - this is the ceramic seal with the spring behind the washer you replaced. Look at the parts diagram under CRANKCASE , you will find a part called...
Forum: Honda
05-26-2008, 09:36 AM
Replies: 4
Views: 657
Posted By Ujoint

When to know it's time for a rebuild

Usually smoke and "out of the ordinary" noises are the pre-requisites for a top end overhaul - - Like Doc said, the leakdown test will tell you most as to where the biggest problem would be.

From...
Forum: Honda
05-24-2008, 10:56 AM
Replies: 27
Views: 32,463
Posted By Ujoint

Which Honda is the best?

<div class="FTQUOTE"><begin quote>Originally posted by: KNOWSALOT

Reliability wise,.... the 1988-1995 TRX300 Fourtrax....hands down. The 1996-2000 models weren't bad, but were built in the USA...
Forum: Polaris
05-24-2008, 10:30 AM
Replies: 12
Views: 5,417
Posted By Ujoint

new belt problems

<div class="FTQUOTE"><begin quote>Originally posted by: marmon

The belt is also under tension at this time which i know is wrong. </end quote></div>

EBS system belt is always under tension,...
Forum: Polaris
05-22-2008, 08:48 AM
Replies: 1
Views: 1,575
Posted By Ujoint

1997 polaris two stroke 250 pull cord replacement

Polaris Industries

http://parts.polarisind.com/Browse/Browse.asp
Forum: Honda
05-21-2008, 09:30 AM
Replies: 1
Views: 561
Posted By Ujoint

How to tell the Year Model from the VIN

I've seen a lot of requests lately on how to find the year model of a quad, So I thought I would post this little bit of information on it to help out.

Modern VIN Numbers have 17 Digits total.
...
Forum: Yamaha
05-21-2008, 09:22 AM
Replies: 4
Views: 1,342
Posted By Ujoint

VIN to model number

I've seen these request a lot lately:
Modern VIN Numbers have 17 Digits total.

The 10th Character of the VIN is the year model

B = 1981 , C = 1982 , D = 1983 , E = 1984 , F = 1985 , G = 1986 ,...
Forum: Yamaha
05-21-2008, 09:13 AM
Replies: 2
Views: 727
Posted By Ujoint

1998 Grizzly Question

Gas leaking from the vent tube most likely indicates the float level is incorrect - either having trash in the float needle seat / worn float needle, Or wear has caused the level adjustment to come...
Forum: Polaris
05-18-2008, 05:29 PM
Replies: 5
Views: 2,180
Posted By Ujoint

Polaris Xpedition 4x4

The complete "power system" from the key is the red/white wires - there should be a circuit breaker shortly after the Red "feed wire" comes off the battery suppling power TO the ignition switch - but...
Forum: Arctic Cat
05-18-2008, 05:01 PM
Replies: 26
Views: 2,818
Posted By Ujoint

Need help with my AC400

Oh, by the way - On the Polaris' and AC's, I did turn the idle screws down to the point of the quads wanting to die - no voltage change until they started to "stumble" - - this was done to eliminate...
Forum: Arctic Cat
05-18-2008, 04:57 PM
Replies: 26
Views: 2,818
Posted By Ujoint

Need help with my AC400

<div class="FTQUOTE"><begin quote>Originally posted by: buckaroo50


Remember under 2000 RPM and the battery is not being charged and the engine is running off the battery - over 2000 RPM and the...
Showing results 1 to 25 of 169
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.