400ex grab bar for wheeling
#1
#2
#3
#4
#6
400ex grab bar for wheeling
i've talked to the CVboyz, most of them jus use the stock set up, i think one of them welded a plate on, and a couple others jus laid a bead across the bar. one thing i've wondered about 400ex grab bars and never figured it out when i owned a 400ex: how is it that company's sell aftermarket grab bars? what standard do they have to go by as far as mounting points are concerned? do people jus cut off the stock one, and fabricate new mounts after they buy the aftermarket one?
#7
Trending Topics
#8
400ex grab bar for wheeling
Yeah dude, just run a few beads of weld acrossed the part of your grab bar that hits.....it will take quite a while for it to wear down, and when it does, add some more weld. I've only done this once so far, and after 3 years it's almost time to do it again.
People do have methods of cutting the stock bar off and fabricating another one on there, but the stocker works fine for me.
-Josh
People do have methods of cutting the stock bar off and fabricating another one on there, but the stocker works fine for me.
-Josh
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)