85-86 LT250r head & cylinder torque specs?
#2
Jeff,
The following specs are out of the Clymer service manual for the 1985-1988 LT 250R. The torque specs for the 1985-1986 cylinder base nuts are 6-8 ft.-lbs for the 2 small nuts and 26-20 ft.-lbs for the 4 large nuts. The cylinder head nuts are spec'ed at 19-22 ft.-lbs. It was a good question as I will be picking up my cylinder tomorrow and getting it all back together tomorrow night!
Good Luck,
RoostKing... 85 LT 250 R.
------------------
The following specs are out of the Clymer service manual for the 1985-1988 LT 250R. The torque specs for the 1985-1986 cylinder base nuts are 6-8 ft.-lbs for the 2 small nuts and 26-20 ft.-lbs for the 4 large nuts. The cylinder head nuts are spec'ed at 19-22 ft.-lbs. It was a good question as I will be picking up my cylinder tomorrow and getting it all back together tomorrow night!
Good Luck,
RoostKing... 85 LT 250 R.
------------------
Thread
Thread Starter
Forum
Replies
Last Post
Steeldon
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
4
09-09-2015 09:38 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)