Lt80 Hard To Start
#11
03-19-2018, 09:04 AM
#12
03-19-2018, 09:17 AM
Join Date: Mar 2018
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
I’ve got it running 3 times so far and I believe I used starting fluid each time. One time it run for 2-3 seconds and died. The next two times I actually rode it around. And I’m pretty sure the plug was wet.
#13
03-19-2018, 09:36 AM
#15
03-19-2018, 07:11 PM
Join Date: Mar 2018
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
#17
03-20-2018, 08:47 AM
Join Date: Mar 2018
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
#18
03-20-2018, 09:07 AM
Head is fine imo.
If the base gasket isn't tore, you can re-use both gaskets.
While apart, you could try placing a rag on top and blowing air down around the crank. Usually it's together and we take the plug out, disconnect the wire to the coil, use rag, and spin motor till most is gone. Then apply full throttle till is starts and cleans out.
If the base gasket isn't tore, you can re-use both gaskets.
While apart, you could try placing a rag on top and blowing air down around the crank. Usually it's together and we take the plug out, disconnect the wire to the coil, use rag, and spin motor till most is gone. Then apply full throttle till is starts and cleans out.
#19
03-20-2018, 12:19 PM
Join Date: Mar 2018
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
Head is fine imo.
If the base gasket isn't tore, you can re-use both gaskets.
While apart, you could try placing a rag on top and blowing air down around the crank. Usually it's together and we take the plug out, disconnect the wire to the coil, use rag, and spin motor till most is gone. Then apply full throttle till is starts and cleans out.
If the base gasket isn't tore, you can re-use both gaskets.
While apart, you could try placing a rag on top and blowing air down around the crank. Usually it's together and we take the plug out, disconnect the wire to the coil, use rag, and spin motor till most is gone. Then apply full throttle till is starts and cleans out.
#20
03-20-2018, 02:41 PM