Clear Tube Methode;starving for gas
#1
Clear Tube Methode;starving for gas
I just put a hot cam in my raptor and rejeted it(it was always a little white from factory). I set the floats using the clear tube methode but I found when i would race down the road it would suck the float boals dry. So i raised the floats and its runs good now, just when i take jumps or go over bumps fuel comes out the over flow lines, is there something wrong with my fuel delivery or whatever, or is this just the way it is.
Thanks for the help
Starter clutch went a few days ago, L&A designs clutch should be here in a few days
Thanks for the help
Starter clutch went a few days ago, L&A designs clutch should be here in a few days
#2
Clear Tube Methode;starving for gas
Im in the same boat,,,my one way is down too.
You have to adjust the tangs so you are sure that the valve will open,,,and close properly (check it visually before you re-install)(to be sure the valve is closing all the way properly,,,and also opening properly)
gotta find the in between i guess
bottom line,,,you should be able to wheelie without dumping fuel,,,,and you should have enough flow to keep your bowls from running dry.
You have to adjust the tangs so you are sure that the valve will open,,,and close properly (check it visually before you re-install)(to be sure the valve is closing all the way properly,,,and also opening properly)
gotta find the in between i guess
bottom line,,,you should be able to wheelie without dumping fuel,,,,and you should have enough flow to keep your bowls from running dry.
Thread
Thread Starter
Forum
Replies
Last Post
ATVC Correspondent
Performance Mods and Project Quads
5
10-10-2015 10:20 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)