CLUTCH WON'T DISENGAGE
 

You guys have been helpfull in the past so mabybe you could help me with this. I replaced the clutch on my warrior and it seems to engage (i can drive it) but it won't disengage, so when i pull in the clutch it still moves, i can't push it when it is in gear as it is always engaged, I checked the plates and have no play. I was thinking maybe i didn't tighten the springs enough, or maybe to much. I tried adjusting it but nothing, maybe more adjusting? I can't figure it out on my own so any help would be very much appreciated. thanks.

CLUTCH WON'T DISENGAGE
 

get a new clutch again

CLUTCH WON'T DISENGAGE
 

did u adjust ur cable tension? if u installed a new clutch and didnt tweek the cable thats prob ur prob

CLUTCH WON'T DISENGAGE
 

Did you soak the new plates in oil , before stacking them?

CLUTCH WON'T DISENGAGE
 

yeah i soaked them in oil over night, i don't think i need a new clutch though does any one else?

CLUTCH WON'T DISENGAGE
 

Did u adjust ur clutch cable?

CLUTCH WON'T DISENGAGE
 

yeah i was adjusting it last night. i was adjusting it at the top should i try adjusting it @ the crankcase?

CLUTCH WON'T DISENGAGE
 

yeah adjust it down there too and thenkeep messing with it till it sits right