Warrior Won't start
 

Okay heres the deal. My warrior acts as if the battery is not connected. No lights, no neutrel light. But it will start if I run cables from the battery to the starter. I have wd-40'ed all the connections and also checked for loose connections. Any help would be appreciated. Thank you.

Warrior Won't start
 

there probably is a loose connection somewere but thats going to be a pain to fined

Warrior Won't start
 

Can that little brass thing near the back on the left side go bad? Or what about the run switch. I took that apart and cleaned it.

Warrior Won't start
 

thats the starter soliniod i think . it may be your problem are the connections on your battery tight

Warrior Won't start
 

Yep the cables are tight everywhere I can see. Fuse is good. I can seem to understand what else it could be. I mean theres not much wiring to these things. I have also taken cable and touched the postive and negative on that starter solinoid and the ATV trys to start. so it's making me think its not the run switch.

Warrior Won't start
 

there is a ground on the left side of the engine where the chain is. you just take off the chain guard thing and there should be a reverse sensor and a black wire bolted to the frame. if it somehow became loose it could cuase all that to happen

Warrior Won't start
 

when u hit the switch does the starter solinod(lil brass thing) make a ticking noise if so replace that and charge your battery and u will b set to go

Warrior Won't start
 

No noise at all when I hit the start switch, NO lights. Its like the battery isn't even hooked up.

Warrior Won't start
 

just replace the soliniod

Warrior Won't start
 

Make sure the battery terminals are clean and tight and well connected....simple but often overlooked.