Blaster won't start
 

My blaster has been sitting for a few weeks and now it wont start. Its got spark, compression, clear jets, clean carb, good reeds, clean air filter. It seems to like kick back when you kick it i dont know what could be causing this. I also just did the top end not to long ago and it ran fine until it sat. Any help would be appreacited.

Blaster won't start
 

Maybe your getting to much fuel. Try and start it and see what plug looks like afterwords. The float might be sticking or fuel valve worn.

Blaster won't start
 

I dont think so. When i pulled the plug it was clean maybe even a little to clean like it was running lean. But i dont think i was running it lean i use the standard 30:1 premix.

Blaster won't start
 

I think you are flooding the cylinder somehow, Are you sure the plug is getting a spark ?

Blaster won't start
 

I tested the to see if it had spark and it did.

Blaster won't start
 

From what information you posted I would draw the conlusion that you may have a carburetion issue of one of the following : too much gas getting into the cylinder, not enough gas getting into the cylinder, bad gas in the float bowl, bad gas in the tank, float sticking, Im sure there are other possibilties also but I myself would look into these first. hope to help. You might could try to pull start it but use caution and be safe[img]i/expressions/face-icon-small-smile.gif[/img]

Blaster won't start
 

Clean your carbs, use fresh gas.