Hey everyone... I've been lurking for a while. I just rebuilt the carb on my 95 wolf (the o-ring on the float needle seat was bad but I figured while I was in there). It was a simple rejetting, re-o-ringing, but now I can't start it. I have good gas flow to the carb and gas is not pouring out of the back end so I know the float system is working... I get good fire with starter fluid then nothing. Choke and throttle seem fine.

Anyone have an idea of where I have most likely gone wrong?

Thanks in advance.

 

Did you replace the float need and seat? If so, did you reset the float level?