Yes zip tie mod is done accelerator pump not spraying fuel |
Any suggestions ? or should I just pull carb to see if line is clogged? |
Have you taken the air box off and looked to see if it sprays gas when you stab the throttle, without it running. It only sprays solid when throttle goes from no throttle to wide open to overcome the quick gulp of air. Think of it like a pump spray bottle. Somebody may have improperly changed the timing of the spray. You would have to take cover off where the zip tie mod is and watch the arm that pushes the rod down that works the accelerator pump diaphragm you just replaced. |
Ok I’ll look into if the rod is being pushed and I’m not getting any fuel out of nosel when the quad is on or off? thanks for input |
Was there a spring between diaphragm and pump cover, when you changed the diaphragm. You can take the float bowl off to check the accelerator pump function. |
Yes it had a new spring I installed https://cimg9.ibsrv.net/gimg/atvconn...f5f9043401.png This is kit I installed |
Can someone verify witch side of diaphragm goes up? i put the way that looked right but not sure? |
The side you don’t see goes up. The side shown is the bottom then spring and cover. |
Ok I hate to admit this but... i flipped over the diaphragm and shot carb cleaner down the passage & it’s spraying gas now and reving up with much less bog i will dial in carb from here i will update when it’s running correctly thanks for all input |
I think your pilot jet is a little big. Should probably be a 45. Is the bike completely stock, aftermarket exhaust, run an open air box? What your elevation where you ride? |
All times are GMT -5. The time now is 01:39 AM. |
© 2024 MH Sub I, LLC dba Internet Brands