Does anyone know what, if anything goes in this little bolt hole? I'm talking about the little threaded hole in the 8-9 o'clock position from the crank. Right on the outter edge of the bearing area. It's only about 1 cm deep. I dont remember anything being there but I have a hard time remembering stuff, sometimes. ENGINE PICS HERE

 

Check out this picture . Dont see anything in that area.
My service manual uses the same picture and I dont see anyhing for that hole.

 

I just took my bottom end apart last night and I didn't see anything in that hole either

 

Thanks guys.. There aren't a lot of good pics in the service manual, & those blown up diagrams didn't really seem to CONFIRM that there wasn't anything there. Hopefully I can get this thing back together without any other delays.