I was hoping that someone could measure something on their Raptor 660 for me. I have attached a picture of the measurement I need. I need from the top of the arch on the frame to the flat bottom. This is for a sportbike engine swap and I am trying to decide if I should get the Raptor 660, based on my engine.

Click Here for the Picture with Measurement Needed.

Thank you in Advance.

Daniel.

 

Hey bud, on my 03 660R, i'm getting about 19 1/4 inches - 19 1/2 inches.....hope this helps!

 

Just curious if that is from the top/bottom of the top tube and from the top/bottom of the bottom tube? Just trying to determine inside dimensions?

Thank you,

Daniel.

 

While you are at it and since you were so accomidating before, can you take another measurement for me? Unfortunately just based on the first measure I requested it looks like i will probably cut my losses and sell the 400EX frame and start with a raptor frame. Again, if you could measure the distance shown in the picture (the distance between the tubes, not on the outside) it would be greatly appreciated.

Please Measure for Me!

Thanks again,

Daniel.

 

hey bud, for the refined first length....i get about 18.5 inches and for the second you asked for (bottom of frame) i get about 9.75 inches...hope this helps and lemme know if you need anything else!

 

ha ha...........I'll measure something for ya!!

 

Well, if we are actually going there, then you probably want to order this first: Ruler for You. Lol. J/K though, seeing that I dont really know you and all.