Hey yall,
new to the forum and really seeking the answer to two things. I purchased a wrecked axi500 last spring for the sole purpose of pulling the motor and wiring harness so put in a rock buggy for my son. Long story short, motor is mounted in a tube chassis, rear output shaft of the motor has been modified and running into a divorced tcase out of a suzuki samurai. Axles are out of a samurai as well. Will be turning 33" tires with the help of low range and gear reduction from tcase. Fox 2.0 air shocks on all 4 corners, electronic power steering out of a saturn vue. Dont have any updated photos of the project but I'm to the point now of cleaning up the wiring harness and lengthening wires and such. This has proven to be the most challenging part if the whole project. I hate everything about electricity and know nothing about it. I have been unable to locate a manual or schematic of the wiring so far. I need to cut out all the excess wires (light switches, 12 volt acc, head light, ect) Do yall know where one can be found or does anyone have one they would mind sharing? I'll post some pictures if I can figure out how. Thanks yall.

 

A few months ago. Air intake has been redone, front end changed some, exhaust re-ran. In the process of cleaning up the electrical, mounting pedals and the master cyclinder now.