my buddy and i have decided to adjust the valve clearnce on his ds 650and the only thing we really need is the torque spec. on the bolts that hold the cam down and the order that you tighten them down in. if any one has a repair manual i would really like a copy of the page if we could. thank you for your time.

thanks again
chris

 

89 in-lbs.

 

thank you very much dose any one know the pattern for torquing them down or do you just use a cris-cross pattern.

thank you
chris

 

The manual doen't say anything about what sequence. What I did was criss cross the inner set and then the outer set.