whats the going rate of a top end job? mine includes a piston rings and bore job. it coming up to $195.00...and i pulled everything off. i had my sons blaster done last season and i could swear i only paid $130.00...
dam this is expensive stuff. this is on an 88 quadracer.

 

I'd say 80 bucks for piston kit, 50 for a bore and hone, and 20 for the gaskets. Hope this helps, Dink

 

I need one too.

 

Your gettin off cheap!

I Just redone the top end on a neighbor kids quad. New piston,rings ect,Bore cyl,intake cam,Cam follower, 2 valves,guides and gasklets.....$600.00 just in parts

 

evhwg - that price sounds about right. It just depends on the price of your piston, rings, gaskets, and bore. Where are you getting your replacement parts from? Also, are you using original Suzuki parts or aftermarket stuff......shop around a little for better prices if necessary. I normally order my own parts rather than have a mechanic or shop do it.

 

i got the parts from the shop. wiseco piston .60 over.
im ordering my own gasket set from nacs.
so the price quoted is for a bore,piston and rings.

 

I just completed two top ends for my kids blasters (burned up two motors the same day???) I bought all parts on ebay (great deals). Here are the prices I paid: Wisco piston kit w/ pin bearing, including shipping - $75, gasket set: $20, bore $35 (0.20 over)(done at auto place - ran great), other cylinder done at Cascade Innovations for $45 (.060 over) - they mic the piston to the cyl. So, $130-$140 total if you do the labor which is very easy - a few hours time -I prefer this because you know it is done right.

Buy all the parts on ebay, save money, have fun!

BTW, I also picked up two complete sets of SS bolts for the Blasters for $12 each on ebay - about half what they cost at Home Depot.(I love ebay!)