My kids and I were jumping a 2' high hill. I landed on the two front tires, it was about a 45 degree angle, and after that the bike started to run poorly. It actually runs as poorly as it did when the belt popped. I had to clear the belt trouble with the plug I bought. Is there some sort of roll over device/switch that would cause this to happen? If so how cdo I clear it?
Thanks,
tech

 

is it running poorly or is it in limp mode. just like with the belt sensor trips? I do believe they have a tilt sensor in them, too.

 

Limp mode. Just like when I cleared the belt problem with the reset plug. Where is the tilt sensor located? Can it be reset?