need help with my dvx Dyna Ignition
#1
need help with my dvx Dyna Ignition
I have a Dyna Ignition on my dvx 400 its from trinity racing and i have no idea how to change the settings for it. I got the bike 2int hand so i dont have a book or anything on this so i was wondering if anyone new how to change it for like racing or a stock setting any help would be appreciated.
#2
My first thought would be to contact dynatec.. they have a faq section on their site.. they make 2 controllers, programmable and non-programmable..anyway think this is what your looking for.....http://www.dynaonline.com/skins/down...3-9P_2-11P.pdf
#3
I have the programmable one and it has a switch to set the curve. It has 2 small switches and on the first switch on the top it has 1 and then 3 on the bottom and then the 2int one has 2 4 and they both move up and down. To chose one but i put the switch to 4 and the other one is still got to be on 1 or 3 so how do i no witch one its really set to. I no it sounds confusing but there's no other way i can think to put it.
#4
i found this picture on the net, I think it might show what you need. If this doesnt look like what you have, you can still call dyna and ask them. The curves are shown in the first link I sent you. http://www.atvpt.com/DynaPrg/DynaPrg003.JPG
Thread
Thread Starter
Forum
Replies
Last Post
Sw00p
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
2
09-24-2015 02:50 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)