Carb setting trouble
#1
Carb setting trouble
Hey, i have a modified brs42mm carb( stock carb) drilled slide, no airbox, no vacume tube...Now that its warm out at low idle i slowly get on the throttle and she seems to hit a flat spot then kickback/ backfire through the carb i can see the intake tube bounce when it does this....as soon as i give it a tiny bit more throttle she gets passed that point and just screems and runs nice and crisp.... I have everything changed in the carb except the pilot jet...im pretty set on the pilot jet being to small and its lean on the bottom thats why i have the flat spot which goes away at higher rpms where the main takes over....is this my problem?
#3
Carb setting trouble
1- Check rpm per Step 8 of Stock Carb Mods - Summary. Also verify float level is correct.
2- Turn pilot screw out from seat 6 turns - If problem goes away - Get larger pilot jet(47.5 or 50) and turn out 3 turns
3- If running with air-lid off and DJ needle - Run in the 3rd notch from top.
OMR
2- Turn pilot screw out from seat 6 turns - If problem goes away - Get larger pilot jet(47.5 or 50) and turn out 3 turns
3- If running with air-lid off and DJ needle - Run in the 3rd notch from top.
OMR
#4
Carb setting trouble
rpm is fine, pilot screw was out 6 turns, changing needle settings seems to have 0 effect [img]i/expressions/face-icon-small-shocked.gif[/img]. Carb did look like it had gunk inside it...thanks to the k and n filter oil....i prob should take it off and clean maybe theres a plugged jet or something somewhere. It ran fine when it was -10 or so but now thats its like +10 outside it does this...ill also do a low rpm run then shut off and check plugs to see the colors.
Thread
Thread Starter
Forum
Replies
Last Post
micheleLeigh
Polaris Ask an Expert! In fond memory of Old Polaris Tech.
1
07-12-2015 02:50 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)