You got to see how I did this!
Dec 27, 2002 | 12:46 AM
#1
Thread Starter
|
Pro Rider
Joined: Dec 2000
Posts: 1,821
Likes: 0
You got to see how I did this!
Hey,
I finally figured out how I wanted to mount my speedo AND my handwarmer switch!!!
Its supper sturdy and just the right height.
I know it does not protect in roll over but hey, I REALLY like where I put it...Tell me what you think!
PICS
If I screwed the link up just click on my Yahoo photos below then the DS-650
I finally figured out how I wanted to mount my speedo AND my handwarmer switch!!!
Its supper sturdy and just the right height.
I know it does not protect in roll over but hey, I REALLY like where I put it...Tell me what you think!
PICS
If I screwed the link up just click on my Yahoo photos below then the DS-650
Dec 27, 2002 | 02:13 AM
#5
Thread Starter
|
Pro Rider
Joined: Dec 2000
Posts: 1,821
Likes: 0
You got to see how I did this!
It was the stock body mounting hardware from TT. I just used a just cut up a pice of steel, shaped it and smoothed it. I put a hole in 1 end. That hole screwed into the top bolt on the dash board. Then I put two holes in the top and bolted the housing on the TT painted it and took pics!. I have the autometer tach.