Guys, i ordered a set of the ASR uppers off ebay cause it was soo cheap i had to try em, BUT i am running brand new TCS shocks and ive heard some rumors the a-arms can hit the shocks< WTF?? has anyone had this happen cause if its true, i wont even run 'em cause the TCS's were way too much to screw up. Seems to me if i had them on and fully compressed and relaxed the suspesiong travel(could use a comealong to winch it down) i could just see if it would touch at any point, there's not that much flex when riding is there..... i mean if they dont touch when i test them in my garage there not going to touch when landing jumps right.?? hmmmmm... if nothing else ill just set my stockers to looses setting and go bottom them out a few times and see if they hit..

whats the answer here guys, lots of you are running ASR uppers, do they hit the shocks or not......please no rumors here, just the facts off your experiance....
thanks
Jetjock16

 

Check you private messages before you install them.
Look at the picture closely - you'll see the dent on the left side of the shock.

 

no problem here

 

If some people have the problem and other don't, it sounds like the camber is set different.

 

Here

 

jetjock if your tcs shocks are like my works shocks the valve body is at the top of the shock only spring and shaft at bottom where the contact may occur

 

thats not a good thing, it will hit the spring instead, i guess thats better than busting the shock but still no good?
Jetjock16