Hey is anyone from 3D design & Fab going to be there? j/k[img]i/expressions/face-icon-small-smile.gif[/img]

Sam you gettin that Raptor dialed in?

 

It's dialed in for sure, need some gearing runs and it's on, should be out to dumont this weekend for some testing, anyone want to go?

 

Sam, We are meeting shaneB @ Dumont oct 15,16. It should be alot cooler, and more people can go. So let me know if you can make it.

 

I can be there on the 17th

 

Pahrump, What will you be riding, do you run the hill?
I guess I could stay till sunday morning and get there Sat. morning. I hope that sand gets some rain.



Sam, Where were you the other weekend? Im callin you out now on the 16th of october. What up, can you make it. I told shaneb your bike was running very strong, he has that radar gun that can calculate 60ft times and we can tune the holeshot. My goal is to hit 63-64mph that weekend.

 

I sure hope to be ready by then. I had a YFZ get stolen from me about 3 weks ago, and now I am building another one from the ground up. Should be ready in a week or so, as soon as my cylinder gets back from plating. I run the hill some, and my old bike did pretty well, this one should do ok too.

I believe it will be weighing in at about 300lbs wet.

Too bad I weigh in at 225!!

 

that sounds good on the 16 and 17th of oct. i will be there, i want to try out a few sprockets combos, i want to see if i can pull 3rd faster or 4th faster up the hill, should be fun..

 

So whats the deal fellows? this weekend or the week of th e16th? please advise.

 

Both...[img]i/expressions/face-icon-small-smile.gif[/img][img]i/expressions/face-icon-small-wink.gif[/img][img]i/expressions/face-icon-small-smile.gif[/img]

 

Nice!!